ZyXEL Communications ZYWALL 35 User Manual page 458

Chapter 23 Policy Route
Table 138 ADVANCED > POLICY ROUTE > Edit (continued)
LABEL
Gateway
Converted Type
of Service
Converted
Precedence
Log
Apply
Cancel
458
DESCRIPTION
Select User-Defined and enter the IP address of the gateway if you want to
specify the IP address of the gateway. The gateway is an immediate neighbor of
your ZyWALL that will forward the packet to the destination. The gateway must be
a router on the same segment as your ZyWALL's LAN or WAN interface.
Select WAN Interface to have the ZyWALL send traffic that matches the policy
route through a specific WAN interface. Select the WAN interface from the drop-
down list box.
Select the Use another interface when the specified WAN interface is not
available. check box to have the ZyWALL send traffic that matches the policy
route through the other WAN interface if it cannot send the traffic through the WAN
interface you selected. This option is only available when you select WAN
Interface.
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic
by choosing Don't Change, Normal, Min Delay, Max Thruput, Max Reliable or
Min Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or Don't
Change.
Select Yes from the drop-down list box to make an entry in the system log when a
policy is executed.
Click Apply to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL 5/35/70 Series User's Guide