Rogue Ap Containment - ZyXEL Communications NWA3000-N Series User Manual

Select an AP and click Edit.
5
When the Edit AP List window opens, configure the following:
Radio 1 OP Mode: Set this to MON Mode to turn the AP into a rogue AP
monitoring device.
Radio 1 Profile: Select your newly created 'Monitor01' profile from the list.
Click OK to save your changes.
6
See also:

4.2.1 Rogue AP Containment

When the NWA3000-N series AP discovers a rogue AP within its broadcast radius,
it can react in one of two ways: If the rogue AP is connected directly to the
network (such as plugged into a switch downstream of the NWA3000-N series AP),
then the network administrator must manually disconnect it. The NWA3000-N
series AP does not allow the isolation of a rogue AP connected directly to the
network.
However, if a rogue AP independent of the NWA3000-N series AP mimics a
legitimate one, then the NWA3000-N series AP can interfere with it by
NWA3000-N Series User's Guide
Chapter 6 on page 83 and Chapter 13 on page
Chapter 4 Tutorials
165.
67