ZyXEL Communications NWA3000-N Series User Manual page 302

Appendix A Log Descriptions
Table 109 CAPWAP Client Logs
LOG MESSAGE
Managed AP Start.
Discovery Type:%s
Managed AP Reset.
Discovery Type:%s
Managed AP End
Connect to WLAN
Controller. WLAN
Controller:%s
Disconnect to WLAN
Controller. WLAN
Controller:%s
Updated configuration
by a WLAN Controller
Success. %s
Updated configuration
by a WLAN Controller
Fail. %s
ReBoot by a WLAN
Controller. WLAN
Controller:%s
Switch Managed AP to
Standalone AP. WLAN
Controller:%s
Firmware upgraded by
WLAN Controller. WLAN
Controller:%s
Apply configuration by
a WLAN Controller
Success. %s
Managed AP
Configuration Flush.
%s
AC IP Change. New
Discovery Type:%s,
WLAN Controller IP: %s
Managed AP Receiving
Complete ZySH
Configuration from AC
302
DESCRIPTION
The CAPWAP Client service started.
1st %s: Discovery type {By DHCP | Broadcast}
Reset the CAPWAP Client service.
1st %s: Discovery type {By DHCP | Broadcast}
The CAPWAP Client service was ended.
The CAPWAP Client connected to the WLAN Controller.
1st %s: WLAN Controller IP Address."
The CAPWAP Client was disconnected from the WLAN
Controller.
1st %s: WLAN Controller IP Address."
The configuration was upgraded successfully by the WLAN
Controller.
1st %s: Partial Updating."
Configuration upgrade by the WLAN Controller failed.
1st %s: Wrong Configuration."
The managed AP was rebooteed WLAN Controller.
1st %s: WLAN Controller IP Address."
The WLAN controller set the managed AP to Standalone
Mode.
1st %s: WLAN Controller IP Address."
The CAPWAP client's firmware was upgraded by the WLAN
controller.
1st %s: WLAN Controller IP Address."
The WLAN controller successfully applied configuration.
1st %s: Complete Updating"
The managed AP reset ZySH for flushing its running-config &
reapplied the startup-config.
1st %s: Reset ZySH Daemon
Changed the managed AP's AC IP.
1st %s: Discovery type {By DHCP | Broadcast}
2nd %s: WLAN Controller IP Address"
The managed AP is receiving total configuration from the
WLAN Controller during CAPWAP protocol handshaking.
(Configuration Change State)
NWA3000-N Series User's Guide