ZyXEL Communications NWA3000-N Series User Manual page 133

Table 45 Configuration > Device HA > Active-Passive Mode (continued)
LABEL
Monitored
Interface
Summary
Edit
Activate
Inactivate
#
Status
Interface
Virtual Router
IP / Netmask
Management IP
/ Netmask
Link Status
Synchronization
Server Address
Sync. Now
Server Port
NWA3000-N Series User's Guide
DESCRIPTION
This table shows the status of the device HA settings and status of the
NWA3000-N series AP's interfaces.
Select an entry and click this to be able to modify it.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
This is the entry's index number in the list.
The activate (light bulb) icon is lit when the entry is active and dimmed
when the entry is inactive.
This field identifies the interface. At the time of writing, Ethernet and
bridge interfaces can be included in the active-passive mode virtual
router. The member interfaces of any bridge interfaces do not display
separately.
This is the master NWA3000-N series AP's (static) IP address and
subnet mask for this interface. If a backup takes over for the master, it
uses this IP address. These fields are blank if the interface is a DHCP
client or has no IP settings.
This field displays the interface's management IP address and subnet
mask. You can use this IP address and subnet mask to access the
NWA3000-N series AP whether it is in master or backup mode.
This tells whether the monitored interface's connection is down or up.
Use synchronization to have a backup NWA3000-N series AP copy the
master NWA3000-N series AP's configuration and certificates.
Every interface's management IP address must be in the same subnet
as the interface's IP address (the virtual router IP address).
If this NWA3000-N series AP is set to backup role, enter the IP address
or Fully-Qualified Domain Name (FQDN) of the NWA3000-N series AP
from which to get updated configuration. Usually, you should enter the
IP address or FQDN of a virtual router on a secure network.
If this NWA3000-N series AP is set to master role, this field displays the
NWA3000-N series AP's IP addresses and/or Fully-Qualified Domain
Names (FQDN) through which NWA3000-N series APs in backup role
can get updated configuration from this NWA3000-N series AP.
Click this to copy the specified NWA3000-N series AP's configuration.
If this NWA3000-N series AP is set to backup role, enter the port
number to use for Secure FTP when synchronizing with the specified
master NWA3000-N series AP.
If this NWA3000-N series AP is set to master role, this field displays the
NWA3000-N series AP's Secure FTP port number. Click the link if you
need to change the FTP port number.
Every NWA3000-N series AP in the virtual router must use the same
port number. If the master NWA3000-N series AP changes, you have to
manually change this port number in the backups.
Chapter 10 Device HA
133