Configuring Ssh - ZyXEL Communications NWA3000-N Series User Manual

Chapter 15 System

15.6.4 Configuring SSH

Click Configuration > System > SSH to open the following screen. Use this
screen to configure your NWA3000-N series AP's Secure Shell settings.
Note: It is recommended that you disable Telnet and FTP when you configure SSH for
secure connections.
Figure 96 Configuration > System > SSH
The following table describes the labels in this screen.
Table 74 Configuration > System > SSH
LABEL
Enable
Version 1
Server Port
Server
Certificate
Apply
Reset
212
DESCRIPTION
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control table to
access the NWA3000-N series AP CLI using this service.
Select the check box to have the NWA3000-N series AP use both SSH
version 1 and version 2 protocols. If you clear the check box, the
NWA3000-N series AP uses only SSH version 2 protocol.
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Select the certificate whose corresponding private key is to be used to
identify the NWA3000-N series AP for SSH connections. You must have
certificates already configured in the My Certificates screen.
Click Apply to save your changes back to the NWA3000-N series AP.
Click Reset to return the screen to its last-saved settings.
NWA3000-N Series User's Guide