Rogue Ap - ZyXEL Communications NWA90AX User Manual

Table 28 Configuration > Wireless > AP Management (continued)
LABEL
Enable WDS Wireless
Bridging
Uplink Selection
Mode
Setup Wireless Bridge
Vlan ID
Wireless Bridge Vlan Setting
Add
Remove
#
Wireless Bridge
Vlan ID
OK
Close
Max Output Power
MBSSID Settings
Edit
#
SSID Profile
Apply
Reset

10.3 Rogue AP

Use this screen to enable Rogue AP Detection and import/export a rogue or friendly AP list in a txt file.
Click Configuration > Wireless > Rogue AP to access this screen.
Chapter 10 Wireless
DESCRIPTION
If you set the Zyxel Device as a root AP, the radio that's bridging with the Zyxel Device
should be in repeater mode.
Be careful to avoid bridge loops. For example, if your root AP and the Zyxel Device are
connected to a switch, and they're also connected to each other using a WiFi connection.
This will create bridge loops.
This field is available only when the radio is in Repeater mode. Select this to enable WDS
wireless bridging on the Zyxel Device. See
Wireless Distribution System (WDS).
This field is available only when the radio is in Repeater mode.
Select AUTO to have the Zyxel Device automatically use the settings in the applied WDS
profile to connect to a root AP or repeater.
Select Manual to have the Zyxel Device connect to the root AP or repeater with the MAC
address specified in the Radio 1 Uplink MAC Address field.
Click this to show the Wireless Bridge Vlan Setting pop-up window. This link is available only
when the radio is in Root AP or Repeater mode.
Click this to add an entry in the table.
Select an entry and click this to remove the selected entry.
This field is a sequential value. It is not associated with any VLAN ID.
Enter a VLAN ID for the wireless bridge. The VLAN IDs you set on your root AP should be the
same as the VLAN ID you set here. See
wireless bridge.
Click OK to save your changes back to the Zyxel Device.
Click Close to close the pop-up window without saving your changes.
Enter the maximum output power (between 0 to 30 dBm) of the Zyxel Device in this field. If
there is a high density of APs in an area, decrease the output power of the Zyxel Device to
reduce interference with other APs.
Note: Reducing the output power also reduces the Zyxel Device's effective
broadcast radius.
Click Edit ( )to open a screen where you can modify the entry's settings. In some tables
you can just click a table entry and edit it directly in the table. For those types of tables small
red triangles display for table entries with changes that you have not yet applied.
This field shows the index number of the SSID
This field shows the SSID profile that is associated with the radio profile.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
NWA50AX/NWA90AX/NWA55AXE Series User's Guide
Section 1.2 on page 12
Section 1.2 on page 12
82
for more information on
for more information on