Edit Monitored Interface - ZyXEL Communications NWA3000-N Series User Manual

Chapter 10 Device HA
Table 45 Configuration > Device HA > Active-Passive Mode (continued)
LABEL
Password
Auto
Synchronize
Interval
Apply
Reset

10.3.1 Edit Monitored Interface

This screen lets you enable or disable monitoring of an interface and set the
interface's management IP address and subnet mask. To access this screen, click
Configuration > Device HA > Active-Passive Mode > Edit.
Figure 59 Device HA > Active-Passive Mode > Edit Monitored Interface
134
DESCRIPTION
Enter the password used for verification during synchronization. Every
NWA3000-N series AP in the virtual router must use the same
password.
If you leave this field blank in the master NWA3000-N series AP, no
backup NWA3000-N series APs can synchronize from it.
If you leave this field blank in a backup NWA3000-N series AP, it cannot
synchronize from the master NWA3000-N series AP.
Select this to get the updated configuration automatically from the
specified NWA3000-N series AP according to the specified Interval.
The first synchronization begins after the specified Interval; the
NWA3000-N series AP does not synchronize immediately.
When you select Auto Synchronize, set how often the NWA3000-N
series AP synchronizes with the master.
This appears when the NWA3000-N series AP is currently using active-
passive mode device HA. Click Apply to save your changes back to the
NWA3000-N series AP.
Click Reset to return the screen to its last-saved settings.
NWA3000-N Series User's Guide