ZyXEL Communications NWA3000-N Series User Manual page 275

The commands in my configuration file or shell script are not working properly.
• In a configuration file or shell script, use "#" or "!" as the first character of a
command line to have the NWA3000-N series AP treat the line as a comment.
• Your configuration files or shell scripts can use "exit" or a command line
consisting of a single "!" to have the NWA3000-N series AP exit sub command
mode.
• Include write commands in your scripts. Otherwise the changes will be lost
when the NWA3000-N series AP restarts. You could use multiple write
commands in a long script.
Note: "exit" or "!'" must follow sub commands if it is to make the NWA3000-N series
AP exit sub command mode.
I cannot get the firmware uploaded using the commands.
The Web Configurator is the recommended method for uploading firmware. You
only need to use the command line interface if you need to recover the firmware.
See the CLI Reference Guide for how to determine if you need to recover the
firmware and how to recover it.
My packet capture captured less than I wanted or failed.
The packet capture screen's File Size sets a maximum size limit for the total
combined size of all the capture files on the NWA3000-N series AP, including any
existing capture files and any new capture files you generate. If you have existing
capture files you may need to set this size larger or delete existing capture files.
The NWA3000-N series AP stops the capture and generates the capture file when
either the capture files reach the File Size or the time period specified in the
Duration field expires.
My earlier packet capture files are missing.
New capture files overwrite existing files of the same name. Change the File
Suffix field's setting to avoid this.
NWA3000-N Series User's Guide
Chapter 21 Troubleshooting
275