Nortel Call Center Server Installation And Maintenance Manual page 1072

Restoring data
Run the server configuration utility to configure your Symposium Call Center
Server. See "To install the product software and database" on page 854 for
details.
Additional steps required for servers in a networking environment
If you just recovered either an NCC server or a server that is connected to an
NCC server for networking, you must perform some additional steps.
If you recover an NCC
server
If you recover a nodal
server connected to an
NCC server
For more information, refer to the Network Control Center Administrator's
Guide (see the section titled "Configuring the communications database").
1072
using the Configuration (nbconfig) utility on the
NCC server, add all of the sites in your multi-site
call center.
using the Configuration (nbconfig) utility on the
NCC server, perform a force synchronization of the
Address Table for all of the sites in your multi-site
call center.
Standard 7.02
Symposium Call Center Server