Setting The Channel Level - Denon AVR-4806 Operating Instructions Manual

Advanced Setup – Part 2
4 CURSOR
Press the
distance between the center speaker and
listening position.
Example: When the distance is set to 12 feet for the
center speaker
The distance changes in units of 0.1 foot (0.03 meters)
or 1 foot (0.3 meters) each time the button is pressed.
Select the value closest to the measured distance.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
When "Step" is selected, you can select the unit of "1
ft (0.1 m)" or "0.1 ft (0.01 m)".
Please note that the difference of distance for every
speaker should be 20 ft (6.0 m) or less. If you set an
invalid distance, a CAUTION notice, such as screen
right will appear. In this case, please relocate the
blinking speaker(s) so that its distance is no larger
than the value shown in highlighted line.
5
ENTER
Press the button to enter the setting.
• The "Speaker Setup" menu reappears.
The AVR-4806 automatically sets the optimum
surround delay time for the listening room.
F F or G G button to set the

Setting the Channel Level

• Use this setting to adjust so that the playback level between
the different channels is equal.
• From the listening position, listen to the test tones produced
from the speakers to adjust the level.
• The level of each channel should be adjusted to 75 dB (C-
weighted, slow meter mode) on a sound level meter at the
listening position.
If a sound level meter is not available adjust the channels by
ear so the sound levels are the same. Because adjusting the
subwoofer level test tone by ear is difficult, use a well
known music selection and adjust for natural balance.
1
CURSOR
Press the
"Channel Level" at the "Speaker Setup"
menu, then press the
• Display the "Channel Level" screen.
2 CURSOR
Press the
"Auto" or "Manual".
Auto:
Adjust the level while listening to the test tones
produced automatically from each speaker.
Test tones are automatically emitted from each
speaker.
Manual:
Select the speaker from which you want to
produce the test tone to adjust the level.
Example: When the "Auto" mode is selected
116
D D or H H button to select the
ENTER
button.
F F or G G button to select the