Setting The Crossover Frequency Individually For The Different Channels; Selecting The Surround Speakers For The Different Surround; Modes - Denon AVR-4806 Operating Instructions Manual

• If "LFE+Main" is set at "Subwoofer Setup", "SW:LFE+Main"
( page 114, 115) is displayed at the top right of the
screen.
• Please set all THX Certifies speakers to small and the
crossover to 80Hz.
• We recommend using with the crossover frequency set to
"FIXED–THX–", but depending on the speaker, setting it to a
different frequency may improve frequency response near
the crossover frequency.
• The crossover frequency mode is valid only when subwoofer
is set to ON, and when one or more speakers are set to
SMALL, as described in section "Speaker Configuration"
settings ( page 113, 114).
Setting the crossover frequency
individually for the different channels
1
CURSOR
Press the
"Advanced" at the "Crossover Frequency"
screen.
2 CURSOR
Press the
speaker to be set.
F F or G G button to select the
D D or H H button to select the
3 CURSOR
Press the
frequency.
• If "LFE–THX–" is selected at "Subwoofer Setup", the
frequencies can only be selected for speakers set to "Small"
at "Speaker Configuration".
• If "LFE+Main" is set at "Subwoofer Setup", the frequencies
can be selected regardless of the speaker size setting.
Selecting the Surround Speakers for the
different surround modes
• This menu is displayed when both surround speakers A and
B are used.
• At this screen preset the surround speakers to be used in
each surround modes.
1
CURSOR
Press the
"Surround Sp Setup" at the "Speaker Setup"
menu, then press the
• Display the "Surround Sp Setup" screen.
119
Advanced Setup – Part 2
F F or G G button to select the
D D or H H button to select the
ENTER
button.