Denon AVR-4806 Operating Instructions Manual page 62

Basic Operation
ENTER
CURSOR
2 Surround parameters y
EFFECT:
This parameter turns the effect signals with multi surround
mode speaker effects on and off in the WIDE SCREEN
mode. When this parameter is turned off, the SBL and SBR
channel signals are equivalent to the SL and SR channels,
respectively.
LEVEL:
This parameter sets the strength of the effect signals in the
WIDE SCREEN mode. It can be set in 15 steps, from "1"
to "15". Set this to a low level if the positioning or phase
of the surround signals sounds unnatural.
SB CH OUT:
• ON:
Playback is conducted using the surround back speaker.
• OFF:
Playback is conducted without using the surround back
speaker.
NOTE:
This operation can be performed directly pressing the
SURROUND BACK button on the main unit's panel.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: "small", "med.s" (medium-small),
"medium", "med.l" (medium-large) and "large". "small"
recreates a small sound field, "large" a large sound field.
SURROUND
PARAMETER
TONE DEFEAT
ENTER
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the
level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set within
the range of 0 to 300 ms.
SW ATT:
This is the parameter for reducing the level of the subwoofer
channel when playing in the EXT. IN input mode. Depending
on the player you are using, the dubwoofer channel's
playback level may seem too high. If so, set "SW ATT" to
"ON".
For DENON players, use with the default settings ("OFF").
Subwoofer ON/OFF:
The subwoofer output can be controlled directly.
62
CURSOR
SURROUND
PARAMETER