Setting The Channel Level - Denon avr-2106 Operating Instructions Manual

Av surround receiver
Hide thumbs Also See for avr-2106:
Table of Contents

Advertisement

Advanced Setup – Part 2
1
CURSOR D D
H H
Press the
or
"Delay Time" at the "Speaker Setup" menu,
ENTER
then press the
button.
• The "Delay Time" screen appears.
2
CURSOR D D
H H
Press the
or
button to select the
speaker to be set.
3
CURSOR F F
G G
Press the
or
distance between the speaker and the listening
position.
The distance changes in units of 0.1 meters each time the
button is pressed. Select the value closest to the measured
distance.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
The difference in distance for the various speaker
settings must not be greater than 6.0 meters.
4
ENTER
Press the
button to enter the setting.
• The "Speaker Setup" menu appears.

Setting the Channel Level

button to select
• Use this setting to balance the playback levels in different
channels and make them appear equal.
• From the listening position, listen to the test tones produced
from the speakers to adjust the level.
• The levels can also be adjusted directly from the remote control
unit (
page 43).
1
Press the
"Channel Level" at the "Speaker Setup" menu,
then press the
• The "Channel Level" screen appears.
button to set the
2
Press the
"Auto" or "Manual".
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Manual:
Select the speaker from which you want to produce the test
tone to adjust the level.
3
Press the
"TEST TONE Start", then press the
button to select "Start".
CURSOR D D
H H
or
button to select
ENTER
button.
CURSOR F F
G G
or
button to select
CURSOR D D
H H
or
button to select
CURSOR F F
42
ENGLISH
Advanced Setup – Part 2
4
When "Auto" mode is selected:
CURSOR F F
G G
Press the
or
button to adjust all
-1
the speakers to the same volume.
• The test tones are emitted from each speaker in the
following order: at 4-second intervals during the first and
second cycle, and at the 2-second intervals during the
third and subsequent cycles.
FL
C
FR
2sp
SW
SL
SBL
SB
When the surround back speaker setting is set to
"1sp" for "Speaker Configuration", this is set to "SB".
Example:
When the volume is set to –12.0 dB while the test tone
is being produced from the Front Lch speaker
The volume can be adjusted between –12 dB and +12
dB in units of 0.5 dB.
4
When "Manual" mode is selected:
CURSOR D D
H H
Press the
or
button to select the
CURSOR F F
-2
speaker, then press the
to adjust all the speakers to the same volume.
5
ENTER
Press the
button to enter the setting.
• The "Speaker Setup" menu appears.
ENGLISH
SR
SBR
1sp
G G
or
button

Advertisement

Table of Contents
loading

Table of Contents