Denon AVR-4806 Operating Instructions Manual page 46

Basic Operation
ANALOG
2 Selecting the analog mode
ANALOG
Press the button to switch to the analog
input.
ANALOG (exclusive analog audio signal playback mode):
The signals input to the analog input terminals are
decoded and played.
NOTE:
• Input mode when playing DTS sources:
Noise will be output if DTS-compatible CDs or LDs are
played in the "ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to
connect the source component to the digital input
terminals (OPTICAL/COAXIAL) and set the input mode to
"DTS".
2 Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
• In the EXT. IN mode
ROOM EQ
Depending on the input signal.
ROOM EQ
ANALOG
2 Input signal display
• DOLBY DIGITAL
• DTS
Depending on the input signal.
• The "DSD" indicator lights when the DENON
LINK or IEEE1394 have been connected and
• PCM
the DSD signals have been inputted (
page 34, 37).
Depending on the input signal.
• The "HDCD" indicator lights when digital
signals are being input with a player that
supports HDCD playback.
The "DIG." indicator lights when digital signals are being
input properly. If the "DIG." indicator does not light, check
whether the digital input component setup (
90) and connections are correct and whether the
component's power is turned on.
AL24 processing is activated when PCM signals are played
while the surround mode is set to PURE DIRECT, DIRECT,
STEREO, MULTI CH PURE DIRECT, MULTI CH DIRECT or
MULTI CH IN.
NOTE:
• The "DIG." indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will
be heard.
46
page 89,