Connecting The Antenna Terminals; Connecting The Control Terminals - Denon AVR-4806 Operating Instructions Manual

Connecting Other Souces

Connecting the antenna terminals

• An F-type FM antenna cable plug can be connected directly.
FM ANTENNA
DIRECTION OF
BROADCASTING STATION
75 Ω/ohms
COAXIAL
CABLE
FM INDOOR
ANTENNA
(Supplied)
Note to CATV system installer
• This reminder is provided to call the CATV system
installer's attention to Article 820-40 of the NEC which
provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of
cable entry as practical.

Connecting the CONTROL terminals

AM LOOP ANTENNA
(Supplied)
AM OUTDOOR ANTENNA
GROUND
2 AM loop antenna assembly
1
Remove the vinyl tie
and take out the
connection line.
4
a. With the antenna
on top any stable
surface.
b. With the antenna
attached to a wall.
Connection of AM antennas
1. Push the lever.
NOTE:
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect
the AM loop antenna.
• Make sure AM loop antenna lead terminals do not touch
metal parts of the panel.
These terminals are used for an external
controller.
Perform the following operation before using an
external controller connected to the RS-232C
terminal:
1. Press the ON/STANDBY button on the main
unit and set the unit to the operating mode.
2. Perform the operation to turn off the power
from the external control.
3. Check that the product has been set to the
standby mode.
After checking the above, check the connections
of the external controller. Operation is possible.
38
Connect to the AM
antenna terminals.
2
3
Bend in the reverse
direction.
Mount
Installation hole Mount on wall, etc.
2. Insert the 3. Return the
conductor. lever.