Setting The Delay Time; Setting The Channel Level - Denon AVR-2106 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 2

Setting the Delay Time

Input the distance between the listening position and each
speaker to set the delay time for the surround playback.
Preparations:
Measure the distances between the listening position and the
speakers.
FL Center
Subwoofer
SL
SBL SBR
1
CURSOR D D
Press the or
"Delay Time" at the "Speaker Setup" menu,
ENTER
then press the button.
• The "Delay Time" screen appears.
2
CURSOR D D
Press the or
speaker to be set.
3
CURSOR F F
Press the or
distance between the speaker and the listening
position.
The distance changes in units of 1 foot each time the button
is pressed. Select the value closest to the measured
distance.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
The difference in distance for the various speaker
settings must not be greater than 20 ft.
4
Press the
• The "Speaker Setup" menu appears.

Setting the Channel Level

• Use this setting to balance the playback levels in different
FR channels and make them appear equal.
• From the listening position, listen to the test tones produced
from the speakers to adjust the level.
• The levels can also be adjusted directly from the remote control
unit (
Listening position
1
Press the
SR
"Channel Level" at the "Speaker Setup" menu,
then press the
• The "Channel Level" screen appears.
H H
button to select
2
Press the
"Auto" or "Manual".
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
H H
button to select the
Manual:
Select the speaker from which you want to produce the test
tone to adjust the level.
G G
button to set the
3
Press the
"TEST TONE Start", then press the
button to select "Start".
ENTER
button to enter the setting.
page 50).
CURSOR D D H H
or button to select
ENTER
button.
CURSOR F F G G
or button to select
CURSOR D D H H
or button to select
CURSOR F F
49
ENGLISH
Advanced Setup – Part 2
4
When "Auto" mode is selected:
CURSOR F F G G
Press the or button to adjust all
-1 the speakers to the same volume.
• The test tones are emitted from each speaker in the
following order: at 4-second intervals during the first and
second cycle, and at the 2-second intervals during the
third and subsequent cycles.
FL C FR
2sp
SW SL SBL
SB
When the surround back speaker setting is set to
"1sp" for "Speaker Configuration", this is set to "SB".
Example:
When the volume is set to –12.0 dB while the test tone
is being produced from the Front Lch speaker
The volume can be adjusted between –12 dB and +12
dB in units of 0.5 dB.
4
When "Manual" mode is selected:
CURSOR D D H H
Press the or button to select the
CURSOR F F
speaker, then press the
-2
to adjust all the speakers to the same volume.
5 ENTER
Press the button to enter the setting.
• The "Speaker Setup" menu appears.
SR
SBR
1sp
G G
or button