Setting The Channel Level - Denon AVR-887 Operating Instructions Manual

Advanced Setup – Part 2

Setting the Channel Level

Set the volume of the various speakers so that the sound output from
the speakers and the subwoofer seems to have the same volume
level.
1 D D H H
Press to select "Channel Level", then press
2
F F G G
Press to set.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output switched
manually.
3 D D H H
Press to select "Test Tone Start", then press
select "Yes".
4
When "Auto" mode is selected:
F F G G
Press to adjust the volume.
-1
• Test tones are output automatically, in the order shown below.
FL C FR SR
(2 speakers)
SW SL SBL SBR
SB
The volume can be adjusted within the range –12.0 dB to +12.0 dB.
4
When "Manual" mode is selected:
D D H H
Press to select the speaker, then press
-2
adjust the volume.
5
ENTER
Press .
1
ENTER
.
3
• To cancel the setting, press H H and select "Level Clear", then press
F F and select "Yes".
F F
to
• To adjust the channel level separately for the different play modes
after setting the channel level, perform the operation on page 36.
(1 speaker)
F F G G
to
¢ Adjusting the test tone using the remote control
2
Adjustment of the test tones using the remote control unit is only
possible in the "Auto" mode and only valid in the STANDARD (Dolby /
DTS Surround) mode. The adjusted levels are automatically stored for
the different surround modes.
1
4
2
-1
3
62
ENGLISH
Advanced Setup – Part 2
unit
[TEST TONE]
Press .
• Test tones are output from the different speakers.
F F G G
Press to adjust the volume.
[TEST TONE]
Press .
ENGLISH