Error Messages - Denon AVR-3310CI Owner's Manual

Error Messages

An error message is displayed if it was not possible to complete
Audyssey Auto Setup due to speaker placement, the measurement
environment, etc. If this happens, check the relevant items, be sure
to take the necessary measures, then perform Audyssey Auto Setup
procedure over again.
NOTE
Be sure to turn off the power before checking speaker connections.
n When Performing Audyssey Auto Setup Over
Again
Press ui to select "Retry", and then press
When Measuring has Stopped
n
RETURN
Press , the "Cancel auto setup?" prompt is displayed.
Press o p and select "Yes", then press
Main remote control
operation buttons
Error messages (examples)
ENTER
.
ENTER
.
:Displaying the menu
Cancel the menu
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
Error contents
• Included setup microphone is not connected.
• Not all speakers could be detected.
• The front L speaker was not properly detected.
• Too much noise in the room for accurate
measurements to be made.
• Speaker or subwoofer sound is too low for
accurate measurements to be made.
• Displayed speaker could not be detected.
• Displayed speaker connected with the polarities
reversed.
:Moves the cursor
:Confirm the setting
(Up/Down/Left/Right)
Measures
• Connect the included setup microphone to the
SETUP MIC jack of the AVR-3310CI.
• Check the speaker connections.
• Either turn off any device generating noise or
move it away.
• Perform again when the surroundings are
quieter.
• Check the speaker installation and the direction in
which the speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may
be displayed even if the speaker is properly
connected. If you are sure the connection is
correct, press ui to select "Skip", then press
ENTER
.
:Return to previous menu