About Error Messages; Check Of The Measurement Results - Denon AVR-1906 Operating Instructions Manual

Easy Setup and Operation

About error messages

• These error screens may be displayed when performing Auto Setup measurement and the automatic measurements can not be
completed because of the speaker arrangement, measurement environment, or other factors. Please check the following matters,
reset the pertinent items, and measure again.
• When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the
measurements when the noise level is low, or switch off the power of the equipment that is producing the noise for the duration
of the measurements.
Screen example
q This screen will be displayed when the speakers
required for producing suitable reproduction have
not been detected.
• The front L or front R speaker was not properly
detected.
• Only one channel of the surround speakers was
detected.
• Sound was output from the R channel when only
one surround back speaker was connected.
• The surround back speaker was detected, but the
surround speaker was not detected.
w This screen will be displayed when the speaker
polarity is connected in reverse.
e This screen will be displayed when accurate
measurements cannot be made due to the input
level of the microphone being too high.
r This
measurement microphone is not connected.
Cause
screen will be displayed when the
Measures
• Check that the pertinent speakers are
properly connected.
• Check the polarity of the pertinent
speakers. For some speakers, this
screen may be displayed even though
the speakers are properly connected. If
so, select "Skip ".
0
• Set up the speakers so that their position
is farther away from the listening
position.
• Lower the volume of the subwoofer
speaker.
• Connect the measurement microphone
to the microphone connector.
10
ENGLISH
Easy Setup and Operation

Check of the measurement results

1
CURSOR D D H H
Press the or button to select an
ENTER
item, then press the button.
The measurement results of each item can be checked
here.
2
ENTER
Press the button.
• The verification screen appears.
Example: Speaker Config. Check
3
ENTER
Press the button again once you have
checked the results.
ENGLISH