Denon AVR-3310CI Owner's Manual page 34

Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
STEP3 Measurement
5
Move the setup
microphone to
the 2nd position,
use ui to select
"Measure", then
ENTER
press .
Measurements for the
2nd position begin.
To skip this step, select "Next 1 Calculation" and proceed to
b
STEP4 .
6
Perform Step 5
repeatedly for the
3rd, 4th, 5th, and 6th
measurements.
When measurements
of the 6th position
are completed,
"Measurements
finished." is displayed.
To skip this step, select "Next 1 Calculation" and proceed to
b
STEP4 .
b Measure at a total of 6 positions, including the main listening
position and positions around it. It is possible to stop the settings
with five positions or fewer, but for better results we recommend
measuring at 6 positions.
STEP4 Calculation
7
On the STEP3
screen, use
ui
to select "Next 1
Calculation", then
press ENTER .
Analysis begins.
Analysis takes several minutes to complete.
b
The time required for this analysis depends on the number
of speakers connected. The greater the number of speakers
connected, the longer analysis will take.

Main remote control
operation buttons
STEP5 Check
8
Use ui to select
the item you want
to check, then press
ENTER .
The measurement result
confirmation screen is
displayed.
Speaker Config. Check
Channel Level Check
Subwoofer or other speakers may be set to a value that does not
b
correspond to the actual distance.
9
Press RETURN
If you want to check another item, so repeat step 8.
10
Press to select "Next 1 Store", then press
i
ENTER
.
STEP6 Store
11
Select "Store" then
ENTER
press .
"Now Storing... Please
wait." is displayed while
the results are being
stored.
NOTE
Do not turn the power off while the settings are being stored.
12
When the screen
shown on the right
appears, unplug the
setup microphone
from the AVR-
3310CI SETUP
MIC jack.
:Displaying the menu :Moves the cursor
Cancel the menu (Up/Down/Left/Right)
Distance Check
Crossover Freq. Check
.
:Confirm the setting
13
Select "Exit" and then press ENTER
Exiting the GUI Menu
n
MENU
Press while the GUI menu is displayed.
The GUI menu display disappears.
NOTE
After performing Audyssey Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey™ Auto Setup again.
• If there is a disparity between the results and the connection status,
or if an error message is displayed, check the error message against
the errors listed in the "Error Messages" section (vpage 32) and
perform Audyssey Auto Setup again.
• If the result still differs from the actual connection status after
remeasurement or the error message still appears, it is possible
that the speakers are not connected properly. Turn the AVR-3310CI
off, check the speaker connections and repeat the measurement
process from the beginning. Turn the AVR-3310CI off, check the
speaker connections and repeat the measurement process from the
beginning.
• If you change a speaker position or orientation, perform Audyssey
Auto Setup again to obtain optimal equalizer correction.
:Return to previous menu
.