Denon AVR-3310CI Owner's Manual page 59

Presetting Radio Channels (Preset Memory)
Your favorite broadcast channels can be preset so that you can tune
them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
[MEMORY]
Press .
3
[SHIFT]
Press to select the block in which the channel
is to be preset, then press [CHANNEL]
preset number.
4
[MEMORY]
Press again to complete the setting.
To preset other channels, repeat steps 1 to 4.
NOTE
Preset channels are erased by overwriting them.
Listening to Preset Channels
Press [CHANNEL] to select the desired preset channel,
ENTER
then press .
You can also operate via the main unit. In this case, perform the
following operations.
<TUNING PRESET> <SOURCE SELECT>
Press , then turn
preset radio channel.
Searching Categories
1
Press .
o p
SR001 Hits 1
CAT : Pops
2
Use to select the category, to use
o p
the desired channel.
to select the
• "UPDATING" is displayed while the encording code is being
updated.
• "SIRIUS UPDATING" is displayed when updating SIRIUS tuner
firmware.
• Refer to "Troubleshooting" – "SIRIUS Satellite Radio" (vpage
103) regarding other messages.
Parental Lock
1
Tune to the channel you want to lock.
2
ENTER
Press for at least 3 seconds.
"Enter Lock Code" is displayed.
3
Enter the 4-digit lock code using
When you enter the correct code, the corresponding channel
is locked.
4
Press ENTER .
to select the
• Channels under Parental Lock cannot be tuned in by performing
Tuning Up/Down or by category search.
• Channels stored in preset memory can be tuned in by the preset
channel select operation, even if Parental Lock is applied.
• When a channel to which Parental Lock is applied is being played,
Parental Lock for that channel is cancelled by performing step 2.
• See "Edit Lock Cord" (vpage 51) for the method of changing
Parental Lock Cord.
• You can also set "Parental Lock" (vpage 51) from the menu.
Channel category
to select
ui
.
uio p
Tuning in Radio Stations – SIRIUS Satellite Radio