Aiwa XR-H33MD Operating Instructions Manual page 6

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6iAA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
To use SHIFT on the remote control
Buttons o have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing SHIFT.
To use FUNCTION on the remote control
FUNCTION substitutes for the function buttons (TAPE DECK 1/
2, TUNER, AU)UD-IN, CD, MD) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically. When tapes are inserted in both decks, both decks
are selected with FUNCTION.
SHIFT
FUNCTION —
"SET-I=
a
POWER
CD
MD
To turn the unit on
Press one of the function buttons (TAPE, TUNER, AUX/D-lN,
CD, MD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
POWER is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.
To turn the unit off
Press POWER.
DEMO (Demonstration) mode
When the AC cord is connected, the display window
demonstrates the functions of the unit. When the power is turned
on, the DEMO display is overridden by the operation display.
When the power is turned off, the DEMO mode is restored.
~
Press II SET during DEMO display. The clock display
appears. (To set the current time, see SETTING THE CLOCK
on page 29.) To re-activate the DEMO mode, press +~.
Flash windows
The windows on the top of the unit and the MD drive light up or
flashe while the unit is being powered on.
To turn off the light of the top window, press while pressing
CD. To turn back on, repeat the above.
To turn off the light of the MD drive, press while pressing MD.
To turn back on, repeat the above.
c If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
~ ENGLISH