Aiwa XR-H33MD Operating Instructions Manual page 20

The sound of the CD does not decline in quality on the recording,
and recording can be done easily with CD MD.
CLEAR
A
n
$i~.
1
1!
1
'-
* During "AUTO FIRST TRACKS RECORDING", the remaining
time of CD is not displayed.
Registering index marks automatically
The track order information in the original CD will be copied as
the index marks.
To
record on a previously recorded
MD
If there is an unrecorded section left on the MD, the new recording
automatically starts from where the previous recording finished.
If you want to start recording from the beginning of a previously
recorded MD, erase the previous recording completely. (See
page 28.)
-DISP
II
1
I J
,1
1 Insert a recordable MD into the disc drive with
the label side up and in the direction of the arrow.
Arrow
2 Press CD and load a CD to be recorded on tray 1.
3 Press CD MD m to start recording.
"CD F MD direct" is displayed and recording begins.
:..., : ,.,:. :,,:;,.. : .
. ... ..... .:. :
During recording, display changes to the elapsed playing time.
When the last track of the CD finishes playing, the recording
stops automatically.
When the recording finishes, "TOC EDIT" is displayed and
the data concerning the contents of the recording are
registered.
To check the remaining recordable time of the MD before
recording starts
Press one of the function buttons except MD, then press DISP.
The remaining recordable time is displayed for 4 seconds.
To stop recording
Press W. The recording stops and TOC data is registered,
To stop playing the CD, press again.
Display information during recording
When DISP is pressed repeatedly during recording, the display
changes as follows.
r
Elapsed playing — 'Remainig time
time of the CD of the CD
1
!_____ Remainig recordable ._l
time of the MD
1
2
3
Insert a recordable MD into the disc drive with
the label side up and in the direction of the arrow.
Press CD and play the track of the CD to be
recorded.
Press CD MD m to start recording.
CD playing returns to the beginning of the current playing
track and recording begins.
When the selected track of the CD finishes playing, the
recording stops automatically and the CD goes to the next
track.
When the recording finishes, "TOC EDIT" is displayed and
the data concerning the contents of the recording are
registered.
The index mark is registered automatically at the beginning
of the track.
m
While "TOC EDIT" is displayed, do not disconnect the AC cord
or shake the unit. Otherwise, the TOC data is not registered
properly.
During recording with CD MD, II cannot be used.
Nothing other than an MD should be inserted intothe disc drive.
Otherwise the disc may become scratched, causing a
malfunction or safety hazard such as an electric shock.
Do not attempt to insert another MD while an MD is already
inside the disc drive.
Do not tilt the unit with a disc inserted. Doing so may cause
malfunction.
19
ENGLISH