Aiwa XR-H33MD Operating Instructions Manual page 36

If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
Is the AC cord connected properly?
IS there a bad connection? (+ page 3)
There may be a short circuit in the speaker terminals.
+ Disconnect the AC cord, then correct the speaker
connections.
Was an incorrect function button pressed?
Sound is emitted from one speaker only.
is the other speaker disconnected?
An erroneous display or a malfunction occurs.
+ Reset the
unit as stated
below.
TUNER SECTiON
There is constant, wave-like static.
c Is the antenna connected properly? (+ page 4)
Is the signal weak?
~ Connect an outdoor antenna.
The reception contains noise interferences or the sound
is distorted.
is the system picking up external noise or muitipath distortion?
+ Change the orientation of the antenna.
+ Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tape does not run.
Is deck 2 in pause mode? (+ page 9)
The sound is off-balance or not adequately high.
Is the playback head dirty? (- page 33)
Recording is not possibie.
Is the erasure prevention tab on the tape broken off? (+ page
1o)
Is the recording head dirty? (+ page 33)
Erasure is not possibie.
Is the erasure head dirty? (+ page 33)
IS a metal tape or CrOz tape being used?
High frequency sound is not emitted.
Is the recording/playback head dirty? (+ page 33)
CD PLAYER SECTION
The CD piayer does not play.
" is the disc correctly inserted? (+ page 11)
Is the disc dirty? (+ page 33)
Is the lens affected by condensation?
+ Wait approximately one hour and try again.
To reset
If an unusual condition occurs in the display window or the
cassette decks, reset the unit as follows.
1 Press POWER to turn off the power.
2 Press POWER to turn the power back on while pressing
CLEAR. Everything stored in memory after purchase is
canceled.
If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting the AC cord, and connect it again. Then
carry out step 2.
MD RECORDER SECTiON
The MD recorder can not be operated
Is there a disc inside the unit.
- Insert a disc.
. Is the lens affected by condensation?
+ Wait approximately one hour and try again,
Sound is noisy
is the unit placed close to an object with a strong magnetic
field such as a television?
+ Move the unit away from the television.
Sound is intermittent
Is the unit placed on an unstable surface with a iot of vibration?
+ Place the unit on a stable surface with no vibration.
Recording is not possibie
Is CD MD pressed when attempting to record from a source
other than a CD.
Is a prerecorded disc inserted?
+ Change to a recordable disc.
Is the disc protected by the record-protected tab on the disc'?
(+ page 22)
35
ENGLISH