Aiwa XR-H33MD Operating Instructions Manual page 23

IH
9
8 Press 1 to stop recording.
(5
When the recording finishes, "TOC EDIT" is displayed and ; j
~,
1
the data concerning the contents of the recording are .,, $ -$
registered.
% Qi
:,L" ,~~
8--
7-"
1
2-"
4,5
6--
3
4
Inselrt a recordable MD into the disc drive with
the label side up and in the direction of the arrow.
Press one of the function buttons and prepare
the !%ourceto be recorded.
~~ord from a ta~e, press TAPE and insert a tape.
~ord from the radio, press TUNER and tune in a station.
To record from a source of equipment connected to DIGITAL
IN t,wminal on the rear, press AUX/D-lN repeatedly until "D-
IN" appears on the display.
" To r(?cordfrom a source of equipment connected to AUX IN
terminal on the rear, press AUX/D-lN repeatedly until "AUX"
appears on the display.
Press MODE twice.
"Mark MODE?" is displayed for 10 seconds.
Within 10 seconds, press ENTER and turn MULTI
JOG to select an index mark mode.
~lister index marks automatically at the beainnina of each
&a.& select "Mark:AUTO?".
~lister index marks every 5 minutes, select "Mark:TIME?".
register without index marks, select "Mark:OFF?".
Within 10 seconds, press ENTER.
Selected mark mode
Press O MD REC.
Unit enters the standby mode and waits until the source name
to be recorded is displayed.
Recordable remaining time
Press II to start recording.
To add index marks during recording
Press ENTER at the desired point during recording.
There may be a case where index marks are not registered
accurately even if the AUTO MARK is selected.
You can not register index marks without registering track
numbers,
—.
To prevent accidental erasure of recorded material
Slide the record-protect tab as shown below,
Slide the tab so that it is completely locked.
'To protect recorded contents
-1
Q
To record
y
'...
J
If a recording is attempted when the tab is set to the protected
position, "Protected" appears on the display. Slide the record-
protect tab to the original position.
/
ENGLISH
22