Setting The Timer - Aiwa XR-H33MD Operating Instructions Manual

Twice as long as the time printed on the MD can be obtained by
using the monaural recording mode. In this case, the recording
sound will be monaural.
1
4,5,7,8
3,6
E=l=al-4'7
9 Press MD REC.
The unit enters the standby mode and waits until the source
name to be recorded is displayed.
MONO flashes.
10 Press II to start recording.
11 Press to stop recording.
When the recording finishes, "TOC EDIT" is displayed and
the data concerning the contents of the recording are
registered.
To
add index marks during recording
Press ENTER at the desired point during recording.
m
When one of the Function buttons is pressed, the extended
recording mode is canceled.
1
2
3
4
5
6
7
8
Insert a recordable MD into the disc drive with
the label side up and in the direction of the arrow.
Press one of the function buttons and prepare
the source to be recorded.
To record from a ta~e, press TAPE and insert a tape.
To record from the radio, press TUNER and tune in a station.
To record from a source of equipment connected to DIGITAL
IN terminal on the rear, press AI.DUD-IN repeatedly until "D-
IN" appears on the display.
To record from a source of equipment connected to AUX IN
terminal on the rear, press AUX/D-lN repeatedly until "AUX
appears on the display.
Press MODE three times.
"REC MODE?" is displayed for 10 seconds.
Within 10 seconds, press ENTER and turn MULTI
JOG so that "REC: MONO?" displays.
Within 10 seconds, press ENTER.
"MONO flashes on the display.
Press MODE twice
"Mark MODE?" i=~yed for 10 seconds.
Within 10 seconds, press ENTER and turn MULTI
JOG to select an index mark mode.
~
W
select "Mark:AUTO?".
To register index marks every 5 minutes. select "Mark:TIME?".
To register without index marks, select "Mark:OFF?".
Within 10 seconds, press ENTER.
M—-*b- ——
" "-mm—am
EXTENDED TIM"ERTE70R-DING
1
2
3
Carry out steps 1 to 5 of "SETTING THE TIMER
RECORDING" on page 30.
Carry out steps 3 to 5 of "EXTENDED RECORDING" on this
page so that "MONO is displayed.
Press POWER to turn the power off after adjusting the volume
and tone.
0 remains on the display after power is turned off (timer
standby mode).
23
ENGLISH