Configuring Batch Onu Binding And Automatic Onu Binding - 3Com S7906E Configuration Manual

To do...
Enter system view
Enter ONU port view
Bind the current ONU port to an
ONU
An ONU port can only be bound with one ONU MAC address. Conversely, an ONU MAC address
can only be bound to one ONU port under one OLT port.
In fiber backup, an ONU can be bound with two ONU ports under two OLT ports acting as backups
for each other.

Configuring Batch ONU Binding and Automatic ONU Binding

In an actual EPON network environment, multiple ONUs may be attached to an OLT. Manually binding
these ONUs to the OLT one by one will bring about tedious binding work and increase the cost and
difficulty of network maintenance. To solve this problem, you can configure batch ONU binding or
automatic ONU binding.
Configuring batch ONU binding
With batch ONU binding configured, the device automatically binds the current quiet ONU MAC
addresses to the ONU ports and generate the binding configuration on the ONU ports, however, the
ONUs joining subsequently will not be bound.
This binding method is applicable to a initially set up network environment where all ONUs are valid.
This method can save a great deal of binding operations. You must use the bind onuid command to
bind the subsequently joining ONUs, thus avoiding automatic registration of invalid ONUs.
Follow these steps to configure batch ONU binding:
To do...
Enter system view
Enter FTTH view
Configure batch ONU binding
Configure automatic ONU binding
With automatic ONU binding configured, the device automatically binds the current quiet ONU MAC
addresses to the ONU ports and generate the binding configuration on the ONU ports, and the ONUs
joining subsequently will also be bound automatically.
Use the command...
system-view
interface onu
interface-number
bind onuid onuid
Use the command...
system-view
ftth
onu bind batch [ slot slot-id ]
3-3
Remarks
—
—
Required
Remarks
—
—
Required
By default, batch ONU binding
is disabled.