Configuring The Maximum Number Of Load-Balanced Routes - 3Com S7906E Configuration Manual

After you enable the BGP ORF capability, the local BGP router negotiates the ORF capability with the
BGP peer through Open messages (that is, determine whether to carry ORF information in messages;
if yes, whether to carry non-standard ORF information in the packets). After completing the negotiation
process and establishing the neighboring relationship, the BGP router and its BGP peer can exchange
ORF information through specific Route-refresh messages.
For the parameters configured on both sides for ORF capability negotiation, refer to
Follow these steps to enable the BGP ORF capability:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Enable BGP route refresh for a
peer/peer group
Enable the non-standard ORF
capability for a BGP peer/peer
group
Enable the ORF IP prefix
negotiation capability for a BGP
peer/peer group
Table 1-1 Description of the both, send, and receive parameters and the negotiation result
Local parameter
send
receive
both

Configuring the Maximum Number of Load-Balanced Routes

Follow these steps to configure the maximum number of load balanced routes:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Use the command...
system-view
bgp as-number
ipv6-family
peer { group-name |
ipv6-address }
capability-advertise
route-refresh
peer { group-name |
ipv6-address }
capability-advertise orf
non-standard
peer { group-name | ip-address
| ipv6-address }
capability-advertise orf
ip-prefix { both | receive |
send }
Peer parameter
receive
both
send
both
both
Use the command...
system-view
bgp as-number
ipv6-family
1-15
—
Required
—
Required
Enabled by default
Optional
By default, standard BGP ORF
capability defined in RFC 5291
and RFC 5292 is supported.
Required
Not supported by default
Negotiation result
The ORF sending capability is enabled locally
and the ORF receiving capability is enabled on
the peer.
The ORF receiving capability is enabled
locally and the ORF sending capability is
enabled on the peer.
Both the ORF sending and receiving
capabilities are enabled locally and on the
peer, respectively.
—
—
—
Table 1-1.
Remarks
Remarks