Local Port Mirroring Configuration Example For Onus - 3Com S7906E Configuration Manual

[DeviceC] interface GigabitEthernet 2/0/3
[DeviceC-GigabitEthernet2/0/3] undo stp enable
[DeviceC-GigabitEthernet2/0/3] port service-loopback group 1
# In tunnel interface view, configure the tunnel to reference service loopback group 1.
[DeviceC-GigabitEthernet2/0/3] quit
[DeviceC] interface tunnel 0
[DeviceC-Tunnel0] service-loopback-group 1
[DeviceC-Tunnel0] quit
# Enable the OSPF protocol.
[DeviceC] ospf 1
[DeviceC-ospf-1] area 0
[DeviceC-ospf-1-area-0.0.0.0] network 30.1.1.0 0.0.0.255
[DeviceC-ospf-1-area-0.0.0.0] network 40.1.1.0 0.0.0.255
[DeviceC-ospf-1-area-0.0.0.0] network 50.1.1.0 0.0.0.255
[DeviceC-ospf-1-area-0.0.0.0] quit
[DeviceC-ospf-1] quit
# Create local mirroring group 1.
[DeviceC] mirroring-group 1 local
# Configure GigabitEthernet 2/0/1 as a mirroring port and GigabitEthernet 2/0/2 as the monitor port of
local mirroring group 1.
[DeviceC] mirroring-group 1 mirroring-port gigabitethernet 2/0/1 inbound
[DeviceC] mirroring-group 1 monitor-port gigabitethernet 2/0/2
5) Verify the configurations
After the above configurations are completed, you can monitor all the packets received and sent by the
marketing department on the server.

Local Port Mirroring Configuration Example for ONUs

Network requirements
As shown in Figure
OLT 3/0/1 of Device A (an S7900E switch) is connected to ONU 3/0/1:1 of an ONU. The ONU is
connected to hosts and a server (a data monitoring device).
Host A, Host B, and Server are connected to UNI 1, UNI 2, and UNI 3 of the ONU respectively.
On Device, remotely configure local port mirroring for the ONU to mirror the traffic received on UNI
1 to UNI 3, so that Server can collect all traffic sent by Host A.
1-7, the customer network is as described below:
1-21