Configure The Onu Bandwidth Allocation And Related Parameters - 3Com S7906E Configuration Manual

To do...
Bring up the
management VLAN
interface
Manual
Config
configurati
ure IP
on
addres
Automatic
ses
allocation

Configure the ONU Bandwidth Allocation and Related Parameters

Complete this task to allocate different uplink/downlink bandwidths based on different terminal service
requirements to realize efficient bandwidth utilization.
Follow these steps to configure the ONU bandwidth allocation and related parameters:
To do...
Enter system view
Enter ONU port view
Enable the ONU downlink
bandwidth allocation policy and
prioritize high-priority packets
Configure the ONU downlink
bandwidth limit
Set the ONU's uplink bandwidth
range and the delay mode of
packet forwarding
Use the command...
undo shutdown
management-vlan-interface
ip address ip-address mask
gateway gateway
ip address dhcp-alloc
Use the command...
system-view
interface onu
interface-number
bandwidth downstream
{ policy | high-priority }
enable
bandwidth downstream
{ max-bandwidth value |
max-burstsize value } *
upstream-sla
{ minimum-bandwidth value1
| maximum-bandwidth value2
| delay { low | high } } *
3-5
Remarks
Required
By default, a management VLAN
interface is down. After the undo
shutdown management-vlan-interface
command is used:
A management VLAN interface is
down if all the Ethernet ports in the
management VLAN of the ONU are
down.
A management VLAN interface is up if
one or more Ethernet ports in the
management VLAN of the ONU are
up.
Either is required.
Required, use either one of the two
methods.
By default, the management VLAN
interface has no IP address.
Remarks
—
—
Required
By default, the downlink
bandwidth allocation policy is
disabled and high-priority
packets are not prioritized.
Optional
By default, the maximum
bandwidth is 999994 kbps, and
the maximum burst buffer is
8388480 bytes.
Required
By default, the minimum
bandwidth of an ONU is 2048
kbps, the maximum bandwidth
is 23552 kbps, and low delay is
used.