After you configure the updating of the ONUs corresponding to all the created ONU ports under an OLT
port, if the ONU port corresponding to an ONU that goes online is created before the update command
is used, the ONU will be updated directly (if it matches the update files); otherwise, the ONU will not be
updated.
Restarting an ONU
Follow these steps to restart an ONU:
To do...
Enter system view
Enter ONU port view
Restart the ONU
Displaying and Maintaining ONU Port Configuration
To do...
Display the global information
about the ONU
Display the IP address
allocation information when the
ONU serves as a DHCP client
Display the information about
the protocols supported by the
ONU
Display multicast control
information
Clear the statistics information
about the packets on an ONU
port
Configuration Examples for ONU Remote Management
Configuration Example for Binding an ONU Port to an ONU
Network requirements
Bind ONU 3/0/1:1 to ONU 1, whose MAC address is 000f-e200-0031, and ONU 3/0/1:2 to ONU 2,
whose MAC address is 000f-e200-3749. ONU 1 and ONU 2 have the same extended OAM version of 2.
Use the command...
system-view
interface onu
interface-number
reboot onu
Use the command...
display vendor-specific
information
display dhcp-client
display onu-protocol [ stp |
igmp-snooping |
dhcp-snooping information ]
display epon-multicast
information
reset counters interface
interface-type interface-number
3-18
Remarks
—
—
Required
Remarks
Available in ONU port view
To display the information of an
ONU, make sure the ONU is
online.
Available in user view