Displaying And Maintaining Gvrp - 3Com S7906E Configuration Manual

To do...
Enter
Ethernet
interface
view or
port-group
view
Configure the hold timer,
join timer, and leave timer
When configuring GARP timers, note that their values are dependent on each other and must be a
multiple of five centiseconds. If the value range for a timer is not desired, you may change it by tuning
the value of another related timer as shown in the following table:
Table 1-2 Dependencies of GARP timers
Timer
Hold
Join
Leave
LeaveAll
The GVRP configuration made on a link aggregation member port can take effect only after the port is
removed from the group. For more information about link aggregation, refer to Link Aggregation
Configuration in the Access Volume.

Displaying and Maintaining GVRP

To do...
Display statistics about GARP
Use the command...
Enter
Ethernet interface interface-type
interface interface-number
view
Enter
Layer-2 interface
aggregate bridge-aggregation
interface interface-number
view
Enter
port-group manual
port-group
port-group-name
view
garp timer { hold | join |
leave } timer-value
Lower limit
10 centiseconds
Not less than two times the hold timer setting
Greater than two times the join timer setting
Greater than the leave timer setting
display garp statistics [ interface
interface-list ]
Required
Use either command.
In Ethernet interface view, the
subsequent configurations apply
to the current port.
In
subsequent configurations apply
to all ports in the port group.
In Layer-2 aggregate interface
view,
configurations
Layer-2 aggregate interface and
all its member ports.
Optional
The default is 10 centiseconds for the
hold timer, 20 centiseconds for the
join timer, and 60 centiseconds for
the leave timer.
Use the command...
1-6
Remarks
port group view,
the subsequent
apply to
Upper limit
Not greater than half of the join
timer setting
Less than half of the leave timer
setting
Less than the LeaveAll timer
setting
32765 centiseconds
Remarks
Available in any view
the
the