Features; Access Volume - 3Com S7906E Configuration Manual

2

Features

The following sections provide an overview of the main features of each module supported by the
S7900E series.

Access Volume

Table 2-1 Features in Access volume
Features
Ethernet Port
Link aggregation
Port Isolation
Service Loopback
Group
This document describes:
Combo Port Configuration
Management Ethernet Interface Configuration
Basic Ethernet Port Configuration
Configuring Flow Control on an Ethernet Port
Configuring the Suppression Time of Physical-Link-State Change on
an Ethernet Port
Configuring Loopback Testing on an Ethernet Port
Configuring a Port Group
Configuring an Auto-negotiation Transmission Rate
Configuring Storm Suppression
Setting the Interval for Collecting Ethernet Port Statistics
Enabling Forwarding of Jumbo Frames
Enabling Loopback Detection on an Ethernet Port
Configuring the MDI Mode for an Ethernet Port
Testing the Cable on an Ethernet Port
Configuring the Storm Constrain Function on an Ethernet Port
Configuring the Connection Mode of an Ethernet Port
Link aggregation aggregates multiple physical Ethernet ports into one
logical link. This document describes:
Introduction to Link Aggregation
Configuring an Aggregation Group
Configuring an Aggregate Interface
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
The port isolation feature allows you to isolate different ports within the
same VLAN. This document describes:
Introduction to Port Isolation
Configuring the Isolation Group
To increase service redirecting throughput, you can bundle multiple
service loopback ports into a logical link, called a service loopback group.
This document describes:
Introduction to Service Loopback Groups
Configuring a Service Loopback Group
2-1
Description