Configuring Dynamic Bandwidth Allocation And Related Parameters - 3Com S7906E Configuration Manual

When the OUI and OAM version number list on an EPON service board changes due to addition or
removal of user-defined list entry, all ONUs under the board will re-register.
It is recommended that you configure the maximum ONU-OLT RTT only when necessary. The
relationship between the RTT and the distance (in meters) from the OLT to the ONU can be roughly
expressed by the formula: RTT = (Distance + 157)/1.6393.
The max-rtt command is applicable to unregistered ONUs only.
The encryption reply timeout time must be less than or equal to the key update time.

Configuring Dynamic Bandwidth Allocation and Related Parameters

Dynamic bandwidth allocation (DBA) is used by an OLT to adjust the uplink bandwidth of individual
ONUs in real time according to the traffic status of the ONUs.
BA is implemented through a request-response mechanism:
An OLT obtains the traffic information of ONUs from the bandwidth requests (REPORT messages)
received from ONUs, uses a suitable bandwidth allocation algorithm to calculate the bandwidth to be
allocated for this cycle within the specified uplink ONU bandwidth range, and notifies the results to the
ONUs through bandwidth authorization (GATE messages). This ensures that uplink data sent by ONUs
will not conflict with each other.
Compared with static (fixed) bandwidth allocation, DBA is more suitable for bursty IP/Ethernet services.
DBA reduces bandwidth wastes and allows for more efficient uplink bandwidth utilization. With DBA
adopted, the order and the time for ONUs to send uplink frames are controlled by the OLT.
There are two types of DBA algorithms: internal DBA algorithm and external DBA algorithm.
The internal DBA algorithm is implemented internally by a chip.
The external DBA algorithm is implemented through loading an external DBA algorithm file.
Follow these steps to configure dynamic bandwidth allocation and related parameters
To do...
Enter system view
Enter OLT port view
Use an
external
DBA
algorithm
Use the internal DBA algorithm
system-view
interface olt interface-number
Load the
specified
dba-algorithm update file-url
external DBA
algorithm file
Use the
specified
dba-algorithm enable extdba
external DBA
algorithm
dba-algorithm enable intdba
Use the command...
2-3
Remarks
—
—
Use either internal DBA
algorithm or external DBA
algorithm.
By default, the internal DBA
algorithm is used.