Configuring Ipv6 Is-Is Basic Functions; Configuration Procedure; Configuring Ipv6 Is-Is Routing Information Control - 3Com S7906E Configuration Manual

Configuring IPv6 IS-IS Basic Functions

You can implement IPv6 inter-networking through configuring IPv6 IS-IS in IPv6 network environment.
Configuration Prerequisites
Before the configuration, accomplish the following tasks first:
Enable IPv6 globally
Configure IP addresses for interfaces, and make sure all neighboring nodes are reachable.
Enable IS-IS

Configuration Procedure

Follow these steps to configure the basic functions of IPv6 IS-IS:
To do...
Enter system view
Enable an IS-IS process and
enter IS-IS view
Configure the network entity
title for the IS-IS process
Enable IPv6 for the IS-IS
process
Return to system view
Enter interface view
Enable IPv6 for an IS-IS
process on the interface

Configuring IPv6 IS-IS Routing Information Control

Configuration Prerequisites
You need to complete the IPv6 IS-IS basic function configuration before configuring this task.
Configuration Procedure
Follow these steps to configure IPv6 IS-IS routing information control:
To do...
Enter system view
Use command to...
system-view
isis [ process-id ]
network-entity net
ipv6 enable
quit
interface interface-type
interface-number
isis ipv6 enable [ process-id ]
Use command to...
system-view
1-2
Remarks
––
Required
Not enabled by default
Required
Not configured by default
Required
Disabled by default
––
––
Required
Disabled by default
Remarks
––