3Com S7906E Configuration Manual page 524

# Configure an IPv4 address for VLAN-interface 100.
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 30.1.1.1 255.255.255.0
[SwitchA-Vlan-interface100] quit
# Configure an IPv6 address for VLAN-interface 101 (the physical interface of the tunnel)
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 address 2002::1:1 64
[SwitchA-Vlan-interface101] quit
# Create the interface tunnel 1.
[SwitchA] interface tunnel 1
# Configure an IPv4 address for the interface tunnel 1.
[SwitchA-Tunnel1] ip address 30.1.2.1 255.255.255.0
# Configure the tunnel encapsulation mode.
[SwitchA-Tunnel1] tunnel-protocol ipv4-ipv6
# Configure the source address for the interface tunnel 1 (IP address of VLAN-interface 101).
[SwitchA-Tunnel1] source 2002::1:1
# Configure the destination address of the interface tunnel 1 (IP address of VLAN-interface 101 of
Switch B).
[SwitchA-Tunnel1] destination 2002::2:1
[SwitchA-Tunnel1] quit
# Create service loopback group 1 to support the tunnel service.
[SwitchA] service-loopback group 1 type tunnel
# Add GigabitEthernet 2/0/3 to service loopback group 1.
[SwitchA] interface GigabitEthernet 2/0/3
[SwitchA-GigabitEthernet2/0/3] undo stp enable
[SwitchA-GigabitEthernet2/0/3] port service-loopback group 1
[SwitchA-GigabitEthernet2/0/3] quit
# Reference service loopback group 1 on the tunnel.
[SwitchA] interface tunnel 1
[SwitchA-Tunnel1] service-loopback-group 1
[SwitchA-Tunnel1] quit
# Configure a static route from Switch A through the interface tunnel 1 to Group 2.
[SwitchA] ip route-static 30.1.3.0 255.255.255.0 tunnel 1
Configuration on Switch B
# Enable IPv6.
<SwitchB> system-view
[SwitchB] ipv6
# Configure an IPv4 address for VLAN-interface 100.
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ip address 30.1.3.1 255.255.255.0
[SwitchB-Vlan-interface100] quit
1-30