traffic on the port exceeds the threshold, the system discards packets until the traffic drops below the
threshold.
The storm suppression ratio settings configured for an Ethernet port may become invalid if you enable
the storm constrain for the port. For information about the storm constrain function, see
Storm Constrain Function on an Ethernet
Follow these steps to set storm suppression ratios for one or multiple Ethernet ports:
To do...
Enter system view
Enter
Ethernet
port/OLT
port view or
port group
view
Set the broadcast storm
suppression ratio
Set the multicast storm
suppression ratio
Set the unknown unicast
storm suppression ratio
As for an Ethernet port belongs to a port group, if you set a storm suppression ratio for the port in both
Ethernet port view and port group view, the one configured the last takes effect.
Setting the Interval for Collecting Ethernet Port Statistics
Follow these steps to configure the interval for collecting port statistics:
To do...
Enter system view
Use the command...
system-view
Enter
Ethernet port
interface interface-type
or OLT port
interface-number
view
Enter port
port-group manual
group view
port-group-name
broadcast-suppression { ratio |
pps max-pps | kbps max-bps }
multicast-suppression { ratio |
pps max-pps | kbps max-bps }
unicast-suppression { ratio | pps
max-pps | kbps max-bps }
Use the command...
system-view
.
1-8
Configuring the
Remarks
—
Use either command.
If configured in Ethernet port
or OLT port view, this feature
takes effect on the current
port only; if configured in port
group view, this feature takes
effect on all ports in the port
group.
Optional
By default, broadcast traffic is
not suppressed.
Optional
By default, multicast traffic is
not suppressed.
Optional
By default, unknown unicast
traffic is not suppressed.
Remarks
—