Configuring Ipv6 Bgp Community - 3Com S7906E Configuration Manual

When creating a mixed eBGP peer group, you need to create a peer and specify its AS number that can
be different from AS numbers of other peers, but you cannot specify AS number for the eBGP peer
group.

Configuring IPv6 BGP Community

Advertise community attribute to an IPv6 peer/peer group
Follow these steps to advertise community attribute to an IPv6 peer/peer group:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Advertise community attribute
to an IPv6 peer/peer group
Advertise extended community
attribute to an IPv6 peer/peer
group
Apply a routing policy to routes advertised to a peer/peer group
Follow these steps to apply a routing policy to routes advertised to a peer/peer group:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Apply a routing policy to routes
advertised to an IPv6 peer/peer
group
When configuring IPv6 BGP community, you need to configure a routing policy to define the
community attribute, and apply the routing policy to route advertisement.
For routing policy configuration, refer to Routing Policy Configuration in the IP Routing Volume.
Use the command...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address }
advertise-community
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
Use the command...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
1-18
Remarks
—
—
—
Required
Not advertised by default.
Required
Not advertised by default.
Remarks
—
—
—
Required
Not applied by default.