Creating An Onu Port; Binding An Onu With An Onu Port - 3Com S7906E Configuration Manual

configurations
ONU device
management
Displaying and Maintaining ONU Port Configuration

Creating an ONU Port

You can manually create or delete an ONU port as needed.
Follow these steps to create an ONU port:
To do...
Enter system view
Enter OLT port view
Create ONU port(s)

Binding an ONU with an ONU Port

An OLT supports ONU authentication based on ONU MAC address and denies illegal ONU access to
the system. ONU authentication can be implemented by binding the ONU to an ONU port. During the
ONU registration:
The OLT broadcasts a discovery GATE message. After receiving the discovery GATE message,
an unregistered ONU sends a REGISTER_REQ message, whose source MAC address is that of
the ONU, at the time granted by the GATE message.
Upon receiving the REGISTER_REQ message, the OLT checks whether the source MAC address
contained in the message is bound with the ONU port of the local end. If yes, the ONU passes the
authentication and the OLT replies with a REGISTER message; otherwise, the ONU cannot pass
the authentication and therefore cannot be registered.
After passing the authentication, the ONU port goes up; that is, the ONU is online.
Before binding an ONU to an ONU port, make sure you have obtained the MAC address of the ONU.
Follow these steps to bind an ONU port to an ONU:
Task
Configuring an ONU to Report Information to the OLT
Configuring Traffic Encryption
Testing the Link Between an ONU and the OLT
Testing the Cable Connected to an UNI Port
Deregistering an ONU
Updating ONUs
Restarting an ONU
Use the command...
system-view
interface olt interface-number
using onu { onu-number1 [ to
onu-number2 ] } &<1-10>
—
—
Required
By default, no ONU port is
created when an EPON card is
started up.
3-2
Remarks
Optional
Optional
For H3C ONUs only
Optional
Optional
Optional
Optional
For H3C ONUs only
Optional
Optional
Remarks