Configuration Prerequisites; Enabling Unauthorized Dhcp Server Detection; Configuring Ip Address Conflict Detection - 3Com S7906E Configuration Manual

S7900e family release 6600 series
Hide thumbs Also See for S7906E:
Table of Contents

Advertisement

Configuration Prerequisites

Before performing this configuration, complete the following configurations on the DHCP server:
Enable DHCP
Configure the DHCP address pool

Enabling Unauthorized DHCP Server Detection

Unauthorized DHCP servers may exist on networks, and they reply DHCP clients with wrong IP
addresses.
With this feature enabled, upon receiving a DHCP request, the DHCP server will record the IP address
of the DHCP server which assigned an IP address to the DHCP client and the receiving interface. The
administrator can use this information to check out any unauthorized DHCP servers.
Follow these steps to enable unauthorized DHCP server detection:
To do...
Enter system view
Enable unauthorized DHCP
server detection
With the unauthorized DHCP server detection enabled, the device puts a record once for each DHCP
server. The administrator needs to find unauthorized DHCP servers from the log information.

Configuring IP Address Conflict Detection

To avoid IP address conflicts, the DHCP server checks whether the address to be assigned is in use by
sending ping packets.
The DHCP server pings the IP address to be assigned using ICMP. If the server gets a response within
the specified period, the server will select and ping another IP address; otherwise, the server will ping
the IP addresses once again until the specified number of ping packets are sent. If still no response is
received, the server will assign the IP address to the requesting client (The DHCP client probes the IP
address by sending gratuitous ARP packets).
Follow these steps to configure IP address conflict detection:
To do...
Enter system view
Specify the number of ping
packets
Use the command...
system-view
dhcp server detect
Use the command...
system-view
dhcp server ping packets
number
2-14
Remarks
Required
Disabled by default.
Remarks
Optional
One ping packet by default.
The value 0 indicates that no ping
operation is performed.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

S7910eS7906e-vS7903eS7903e-sS7902e

Table of Contents