Table of Contents
Advertisement
3.3 Setting Output Specifications
J Output assignments
F Standard type
Some output specifications are different according to controller type,
standard or position-proportional. The following table summarizes
which output-related parameter settings are supported.
Parameter
Control output 1 assignment
Control output 2 assignment
Auxiliary output 1 assignment
Auxiliary output 2 assignment
Direct/reverse operation
Control period (heat)
Control period (cool)
Output assignments are described according to controller type.
• Thirteen outputs are supported. These functions are assigned to con-
trol outputs 1 and 2, and auxiliary outputs 1 and 2.
• Restrictions on assignment destination are placed on some of the out-
puts.
• The following table shows where outputs may be assigned to.
Assignment
Destination
Destination
Output Function
Control output (heat)
Control output (cool)
Alarm 1
Alarm 2
Alarm 3
HBA
LBA
Time signal 1
Time signal 2
Program end
Stage output
Error 1 : Input error
Error 2 : A/D convertor error
With control output (cool), the conditions for switching from standard control
to heating and cooling control are reached when the output function is assigned
at the cooling side during heating and cooling control.
In other words, heating and cooling control is carried out when con-
trol output (cool) is assigned, and standard control is carried out
when output is not assigned. For details on heating and cooling con-
trol, see Chapter 4 Applied Operation/4.1 Selecting the Control Meth-
od (page 4-2).
3.3 Setting Output Specifications
Standard
(F Indicates that an output specification is supported.)
Control Output
1
2
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
Position-
proportional
Type
Type
F
F
F
F
F
F
F
F
F
F
Auxiliary Output
1
2
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
F
3--7
Advertisement
Chapters
Table of Contents
