Omron E5EK PROGRAMMABLE TYPE User Manual page 153

F A group
F B group
About Setting Levels
Bit Description
0 Heating side output
1 Cooling side output
2 Alarm output 1
3 Alarm output 2
4 Alarm output 3
5 LBA output
6 HBA output
7 Run/Reset
8 Auto/Manual
9 Remote/Local
10
11 AT
12 Hold
13 Wait
14
15
Bit Description
0 Setting level
1
2 Control output 1 type
3 Control output 2 type
4
5 Input error
6 A/D converter error
7 CT overflow
8 CT hold
9 Potentiometer error
10
11 Time signal 1 output
12 Time signal 2 output
13 Ramp/soak
14 Program end
15 During standby
*1 Always "OFF" at linear output
*2 Always "OFF" when output is not assigned
*3 During position-proportional control, output is Open.
*4 During position-proportional control, output is Close.
*5 When the ON time during control output is less than 190 ms, the heater current to
which
" 1" is set and the previous current value is held.
*6 "ON" while the No.2 display indicates [
see page 4-15.
To return to setting level 0 from setting level 1, issue the "software reset" com-
mand. If the parameter write command is issued for the setup, expansion and
option modes in setting level 0, an error occurs, and the end code (0D = Com-
mand cannot be executed) is returned.
6.4 Commands and Responses
[1]
*3 ON OFF
*4 ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
Reset Run
Manual Auto
Remote Local
AT execution OFF
During hold OFF
During wait OFF
[1]
1 0
Linear Pulse
Linear Pulse
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
Ramp Soak
ON OFF
ON OFF
]. For details on the [
[0]
*1
*1
*2
*2
*2
*2
*2
[0]
*5
*2
*2
*6
] indication,
6--11