Omron E5EK PROGRAMMABLE TYPE User Manual page 20

CHAPTER 1 INTRODUCTION
F Expansion mode
F Option mode
F Calibration mode
J Selecting modes
1--10
This is the mode for setting expanded functions. In this mode, you can
set SP setting limitter, switching between advanced PID control or ON/
OFF control, program time unit, selection of step time/rate of rise pro-
gramming, time unit of ramp rise rate, and the time for automatic re-
turn to the monitoring display.
This is the mode for setting optional functions. You can select this mode
only when an option unit is mounted in the controller. In this mode,
you can set the communications conditions, transfer output and event
input parameters to match the type of option unit mount in the control-
ler. Heater burnout alarm function and position-proportional travel
time are also located in this mode.
This mode is provided so that the user can calibrate inputs and output.
When calibrating input, the selected input type is calibrated. Whereas,
transfer output can be calibrated only when the communication unit
(E53-AKF) is set in the controller.
The following diagram shows the order in which modes are selected.
1 second min.
Level 0 mode
1 second min.
Program mode
1 second min.
Level 1 mode
1 second min.
Level 2 mode
1 second min.
Setup mode
1 second min.
Expansion mode
1 second min.
Option mode
1 second min.
Calibration mode
• To select the menu display in any of the above modes (excluding the
protect mode and manual mode), press the
mum. When you have selected the menu display, the previous mode is
selected. For example, if you selected the menu display while in the
level 0 mode, the No.2 display changes to [
• To move to the desired mode after you have entered the menu display,
select the desired mode using the
key for one second minimum. The display switches to the first
parameter of the mode that you specified.
Power ON
+
1 second min.
RUN/RST
RUN/RST
1 second min.
keys and hold down the
Manual mode
+
1 second min.
+
+
RUN/RST
1 second min. 1 second min.
Protect mode
+
key for 1 second mini-
] as shown on the left.