Settings For The C/Cv Series I/O Table Window - Omron CX-PROGRAMMER V9 Operation Manual

OMRON
1, 2, 3...

Settings for the C/CV Series I/O Table Window

The C/CV Series I/O Table Window is displayed when the PLC is not a CS/CJ/CP-series PLC.
Creating an IO Table
Creation of an IO Table whilst connected to a PLC causes the Actual IO Table in the hardware to be written to the
Registered IO Table. An IO Table can also be edited offline and stored to file, this method is usually employed
when designing a PLC's IO Table.
To create an IO Table, Select Create from the Options menu.
Slot Allocation
Use the following procedure to allocate a unit to a slot.
1, 2, 3...
Slots can also be allocated by transferring the rack information from the PLC. Refer to IO Table Component in this
chapter for information regarding transferring IO Table information from the PLC.
For CS/CJ/CP series PLCs, the IO fields for racks, slots and units information can be edited directly in the IO
Table tree.
Only those units in the Registered IO Table for CS/CJ/CP series PLCs, C200H (including C200HS/X/G/E) PLCs
and CV/CVM1-series PLCs can be edited.
1. Select the desired Special I/O Unit or CPU Bus Unit in the I/O table and select File – Print
from the pop-up menu. The Print Dialog Box will be displayed.
Option
Function
I/O Table
Prints the I/O table.
Special Unit Settings
Prints a parameter list of the Special I/O Unit or CPU Bus Unit settings.
I/O Table + Special Unit Settings
Prints the I/O table and a parameter list of the Special I/O Unit or CPU Bus Unit settings.
2. Select the desired print option and click the OK Button. The Print Dialog Box will be
displayed.
3. To preview a print job, select File – Print Preview, select the desired print option in the
Print Dialog Box, and click the OK Button.
Note: When making parameter settings for a Special I/O Unit or CPU Bus Unit in the I/O
Table Window and transferring data from the PLC Memory Window, a warning will be
displayed if the addresses in the transferred PLC data file overlap the allocated DM
Area or allocated CIO Area addresses set for the Special I/O Unit or CPU Bus Unit in
the computer's I/O Table Window.
Always click the No Button if you do not want to overwrite the actual PLC's (CPU
Unit's) allocated DM Area or allocated CIO Area address data with the PLC data table
data after the Unit settings data has been transferred to the PLC (CPU Unit). After
cancelling the write operation, remove the PLC data table's allocated DM/allocated
CIO area from the areas that will be transferred and then transfer the data again.
1. Select an empty slot in the IO Table component.
2. Click the right-mouse button and select a unit. For Single and Multiple IO Units a
secondary selection is required from the right-mouse button menu. The type of PLC series
and individual rack configurations determine the units that can be installed and therefore
the content of the right-mouse button menu. The types of unit that can be selected are
described in following paragraphs.
PART 2: CX-Server PLC Tools
CHAPTER 3 – IO Table Component
CX-Server PLC Tools_ Page 27