Omron CX-PROGRAMMER V9 Operation Manual page 28

Unit Versions and Programming Devices
Unit Versions and Programming Devices for CJ2 CPU Units
CPU Unit Functions
Functions for unit
CJ2H-CPU6@-EIP
version 1.0
Unit version 1.0
Functions added
CJ2H-CPU6@-EIP
for unit version
Unit version 1.1
1.1
Functions added
CJ2H-CPU6@
for unit version
Unit version 1.1
1.1
Functions added
CJ2H-CPU6@-EIP
for unit version
Unit version 1.2
1.2
Functions added
CJ2H-CPU6@
for unit version
Unit version 1.2
1.2
Functions added
CJ2H-CPU6@-EIP
for unit version
Unit version 1.3
1.3
Functions added
CJ2H-CPU6@
for unit version
Unit version 1.3
1.3
Functions for unit
CJ2M-CPU@@
version 1.0
Unit version 1.0
CJ2M-CPU@@
Functions for unit
version 2.0
Unit version 2.0
×: Cannot be used, ∆: Can be used except for new functions added for unit versions, ❍: Can be used
Note 1. It is not necessary to upgrade the version of the CX-Programmer if functionality that was
enhanced for the upgrade of the CPU Unit will not be used.
2. CX-Programmer version 8.1 or higher is required to use the functions added for unit
version 1.1. The high-speed interrupt function and changing the minimum cycle time
setting in MONITOR mode, however, are also supported by CX-Programmer version
8.02.
3. A Programming Console cannot be used with a CJ2H CPU Unit.
CX-Programmer version 4.0 or higher must be used to enable using the
functions added for CPU Unit Ver. 2.0. The following tables show the
relationship between unit versions and CX-Programmer versions.
Ver. 7.1 Ver. 8.0 Ver. 8.1
or
lower
× ❍ ❍
× ∆ ∆
× ∆ ∆
× ∆ ∆
× ∆ ∆
× ∆ ∆
× ∆ ∆
× × ×
× × ×
Required Programming Device
CX-Programmer
Ver. 8.2 Ver. 8.3
❍ ❍ ❍
❍ ❍ ❍
❍ ❍ ❍
∆ ∆ ❍
∆ ∆ ❍
∆ ∆ ∆
∆ ∆ ∆
× × ×
× × ×
Ver. 9.0 Ver. 9.1 Ver. 9.12
❍ ❍
❍ ❍
❍ ❍
❍ ❍
❍ ❍
❍ ❍
❍ ❍
❍ ❍
∆ ❍
CX-Programmer_Page (
xxv
)