Omron CX-PROGRAMMER V9 Operation Manual page 162

OMRON
Instruction Editing
The Edit Instruction dialog allows an instruction to be selected and entered into the Ladder program.
The dialog can be displayed in two forms, either: simple dialog mode or detailed dialog mode. The default
mode can be set in the Diagram tab in the Options dialog. To change the simple dialog mode to a detailed
dialog mode, select Detail pushbutton.
Use the following procedure to edit instructions in simple dialog mode.
1, 2, 3...
Note: When inputting operands for special instructions using CX-Programmer version 5.0 or higher,
symbols can be filtered using symbol names and I/O comments and displayed in a list. Click the
4. Select the contact or coil to monitor.
5. Select the Differential Monitor button from the toolbar. The Differential Monitor dialog
is displayed.
6. The address associated with the contact or coil selection is displayed in the Address field.
Select an Edge option.
7. Select the Sound setting to retrieve audio whilst monitoring.
8. Select the Start pushbutton to start monitoring. The Start pushbutton becomes a Stop
pushbutton.
9. Select the Stop pushbutton to cancel monitoring. Select the Close pushbutton to exit the
dialog.
10. Select the Toggle PLC Monitoring button from the toolbar to stop monitoring.
1. Double-click on the instruction field in the Ladder program. The Edit Instruction dialog is
displayed.
2. Enter an instruction, either by name or by number. When a correct number has been
entered (of the correct number of digits for the PLC type), the instruction name is
automatically substituted. To insert an instruction with immediate Refresh properties,
apply an exclamation mark ('!') to the beginning of the instruction. To insert a
differentiated instruction, apply a '@' symbol to differentiate up or a '%' symbol to
differentiate down at the beginning of the instruction. When the Show with comment
dialog option is selected in the Options dialog, a comment dialog will appear after
entering an address or a symbol name.
Note: Check the Show with comment dialog option in the Diagram tab of the Options dialog to
display a comment dialog. The dialog is displayed after the OK pushbutton is selected
on the Contact or Coil dialog.
3. Enter operands in the same text box with a space between the instruction and each
operand (see below for more details about entering operands).
4. Select the OK pushbutton to complete the operation. Select the Cancel pushbutton to
abort the operation.
PART 1: CX-Programmer
CHAPTER 4 – Reference
CX-Programmer _Page 79