Clearing And Filling Data Areas - Omron CX-PROGRAMMER V9 Operation Manual

PART 2: CX-Server PLC Tools
CHAPTER 2 – PLC Memory Component

Clearing and Filling Data Areas

A whole data area can be cleared by clicking on the Clear Data Area button from the toolbar.
A whole data area can be populated with a particular value. Use the following procedure to fill a data area with a
single value.
1, 2, 3...
CX-Server PLC Tools_Page 12
• In the PLC Memory window, both individual bits for each word and the
hexadecimal value of the word can be monitored at the same time if the display
format is set to BIN (binary).
1. Open a data area by double-clicking a data area from the Data Area Workspace in the
Memory tab.
2. Select the Fill Data Area button from the toolbar. The Fill Data Area dialog is displayed.
3. The Fill operation can be performed on the memory areas that have been opened in the PLC
Memory component. Select the associated setting to fill that area.
4. Supply the value in the Value field.
5. Select the appropriate Fill Range option, either All, Visible Area Only or the selection
currently highlighted by the cursor.
6. Select a Value option, either Binary, Binary Coded Decimal, Decimal, Signed Decimal or
Hexadecimal.
7. If required, select a Set Status Value setting and the appropriate On or Off option.
8. Select the Fill pushbutton to accept the settings or the Cancel pushbutton to abort the
operation.
OMRON