Disabling Autorate; Resetting Autorate - Paradyne 7974 User Manual

Disabling AutoRate

The AutoRate function is controlled from the Network Interface Options screen and
allows you to enable or disable the AutoRate feature. The AutoRate option is only
available if the unit is configured as an LTU.
To access the Network Interface screen, follow this menu selection sequence:
The AutoRate option defaults to Enable.
Procedure
To disable AutoRate:

Resetting AutoRate

The Reset AutoRate function of the Control branch causes the unit to repeat the
AutoRate sequence. The unit attempts to establish the DSL link at the highest rate
(or the value of DSL Line Rate, which represents the AutoRate ceiling when
AutoRate is enabled). If the link fails, the next lower rate is tried until the link is
established.
To access the Reset AutoRate screen, follow this menu selection sequence:
7900-A2-GB21-20
Main Menu Configuration
main/config/network
Port Status
Margin Threshold:
Excessive Error Rate Threshold:
AutoRate:
DSL Line Rate:
EIA-530 Payload Rate
Transmit Attenuation
Peer IP Address:
Circuit Identifier:
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
1. Position the cursor in the AutoRate field and press the spacebar.
The AutoRate field toggles to Disable and the DSL Line Rate field appears.
2. Enter a DSL Line Rate and press Enter.
Main Menu Control
December 2001
3. Initial Startup and Configuration
Current Configuration
NETWORK INTERFACE OPTIONS
Reset AutoRate
Network
Model: 797x
Enable
–3db
1E–5
Disable
1552 kbps
1536 kbps
0dB
111.255.255.000 Clear
Clear
MainMenu Exit
3-15