Running Network Tests - Paradyne 7974 User Manual

Running Network Tests

Network tests require the participation of your network service provider. To access
the Network Tests screen, follow this menu selection sequence:
Use the Command column to start or stop a test. When the Status column shows
that a test is Inactive, Start is displayed; when a test is Active, Stop is displayed.
Position the cursor at the desired Start or Stop command and press Enter. The
Results column displays the test duration.
7900-A2-GB21-20
Model 7974 (sample screen in
Main Menu Test Network & DSX-1 Tests
Model 7975 (sample screen below):
Main Menu Test Network Tests
Model 7976 (sample screen in
Main Menu Test Network & G.703 Tests
main/test/network
Test
--------------------------------------------------------------------------------
Local Loopbacks
Network Line Loopback:
Remote Loopbacks
Send Line Loopback: Down
Network Pattern Tests
Send and Monitor 511
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
ResetMon
NOTE:
Send and Monitor 511 is displayed on the screens but is not available in this
release. When Send and Monitor 511 is enabled, ResetMon will be available
to reset the error counter to zero.
December 2001
DSX-1 Tests (Model 7974)
G.703 Tests (Model 7976)
NETWORK TESTS
Command Status Results
Start Inactive 00:00:00
Send Inactive 00:00:00
Stop Active hh:mm:ss - Errors 99999+
8. Testing
on page 8-6):
on page 8-14):
Model: 7975
MainMenu Exit
8-3