Configuring Autorate - Paradyne Hotwire 7976 Installation Instructions Manual

Configuring AutoRate

Î
16
The M/SDSL AutoRate function is controlled from the Network Interface Options
screen and allows you to enable or disable AutoRate only from a unit configured
as an LTU. To access the Network Interface screen, follow this menu selection
sequence:
NOTE:
AutoRate is designed to find the best rate possible for your DSL loop
conditions. After the DSL loop is up units should be configured to run in fixed
rate.
Main Menu Configuration
main/config/network
Margin Threshold:
Excessive Error Rate Threshold:
AutoRate
DSL Line Rate
Peer IP Address:
Circuit Identifier:
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
March 1999
Network
NETWORK INTERFACE OPTIONS
Hotwire
Model: 7976
–3db
1E–6
Disable
528
111.255.255.000 Clear
Î Î
Clear
MainMenu Exit
7976-A2-GZ40-00